Lift out the new sink and attach the basket strainer and faucet. Place the drain and strainer in their respective holes and tighten with the washer and nut that came with the assembly. Carefully place the new sink into the hole.
To lift the sink, tap in shims as you go. Place plumber’s putty around the new drain and strainer.
This could cause domestic strife, especially if the job turns into a half day or longer project, so make sure the valves work before going to the home center. Once the entire project is complete and the new supply lines are attached to the faucet, fasten the old supply lines to the shutoff valves.
This project requires some moderate do-it-yourself skills, but it can be completed in an afternoon. If you discover a puddle of water in the cabinet under your sink, it may be caused by a leaky basket strainer. Jan 18, · how to replace a kitchen sink.
Reach over the front of the sink, or have an assistant hold the screwdriver from above. Sink replacement is a straightforward project that you can probably tackle yourself.
Replace the basket strainer yourself in just an hour and save the cost of a visit from the plum. Attach the dishwasher drain line to the waste nib of the tailpiece. Then look at the countertop from under the sink for areas that are too spongy to support sink clips or support the sink itself.
It's not so easy to install a kitchen sink without destroying your countertop, but a diyer with average skills can complete the replacement in about four hours. All text shared under a creative commons license.
Align the mark on the sink with the one on the counter. Cut the locknut if all else fails, chuck a metal cutoff wheel into a rotary tool and cut the locknut. If the shutoff valves under your sink don’t work or you don’t have any, you’ll have to turn off the water supply to the entire house while replacing the sink.
If necessary, modify the countertop opening using a jigsaw, router or tile cutter. Set the new sink in the countertop hole to verify that it fits.
Trace the outline and create a new cutout with a jigsaw. If your new sink has larger dimensions than the current countertop opening, turn the sink upside-down where you want it on the countertop. Reattach any clamps that hold the sink to the counter.
Set the new sink down into the countertop to test its fit. Face the clips away from the sink with the open mouths towards the counter.
You can pick up all the necessary supplies at a hardware store or home center. Check the fit of the sink in countertop; trim the hole with the jigsaw, if necessary. Disconnect the old disposer from the sink.
Armed with only a handful of tools, richard trethwey installed this kitchen sink and faucet with little more than a morning's work.when the sink is removed, remove all of the old caulk so that the edge around the hole where the sink will go is clean. Lift out the new sink and attach the basket strainer and faucet.
But an ugly steel band running around an almond- or avocado-color sink? After turning off views: quick and easy fix for a leaky kitchen sink drain.
Wedge the sink lay a flat board across the cabinet bottom. Place the faucet back and reattach the tubing.